The ramblings of a computer geek
Using Data Centre/Center Expert and adding an APC ATS switch, even though the configuration was correct, FTP was enabled and the relevant settings set for SNMP for the relevant IP addresses the following error is observed in the Data Centre Expert “Device status may be inaccurate due to attempt to transfer DDF failed”. After much … Read more
I recently purchased a 2 Bay Synology 720+ NAS, however at the time of purchase I only had enough money to buy one drive and then wanted to add the second one at a later date. I also wanted to ensure that these were installed with a Mirror for 1 drive fault tolerance. The answer … Read more
I recently bought the Tado Smart Thermostats for my house to attach to my radiators. You’ll be familiar with such things as Hive and Nest which are Smart Thermostats, essentially these just make your Heating Thermostat you’ll typically have in your hall or landing into your home Internet enabled, so you can control it from … Read more
I had a bit of a read about that issue you were talking about with the fire suppression system causing system outages for Channel 4 recently (article). The reports all used seem to use the phrase “sucked the air out of the room”, this would imply a vacuum, which it wouldn’t have been. So in … Read more
The Synology NAS range can be used to run the Plex Media Server. However the Plex service needs to be configured with permissions to read your media files. In my example I have a Shared Folder on the NAS called “tv”, and I want Plex to be able to read, index and play these files. … Read more