The ramblings of a computer geek
So looking for something to use your Raspberry Pi for? I had a Mk1 Raspberry Pi laying around and thought it might be good to set it up as a SSH gateway, so I could easily and securely access my home machines when out and about. These instructions assume you have a Raspberry Pi which […]
More...If you need to test connectivity between two VMKernel ports VMK’s you can use the following command: If you have seperate IP stacks for different types of VMkernel ports you need to add this stack name to the command too:
More...From time to time you need to run normal POTS telephone over structured cabling, the main issue is that in the UK the pin outs can be different from the rest of the world, so buying a BT plug to RJ45 cable doesn’t always work. Below is a diagram of the cabling pinouts required for […]
More...Here is a one liner to allow you to do this: Image Attribution: CHUTTERSNAP
More...To easily find where your disk space is being used from the command line you can use the NCDU utilty. To run this use:
More...After an upgrade to ESXi 5.5 from ESXi 5.1, all the networking on the host stopped working, as I had already upgraded other BL490c G7 blades with (seemingly) identical hardware but upon upgrading this one the NICS were detected but there was no connectivity through the chassis, the flex-10 to the host. All checks on […]
More...Had to do a bit of configuration on an HP c7000 blade chassis the other day. There was a need to have two separate uplink pairs going to two different pairs of switches from the single chassis. I needed to provide both uplink paths to each host within the chassis (they were ESXi hosts). Here […]
More...If you like me, don’t want to have an admin prompt each time you want to save a file to a server you can disable UAC, by ensuring that all Administrators of the server don’t require approval to make minor changes. So if you say had a file on the C: drive you were trying […]
More...While doing some housekeeping on an Exchange 2010 server, I needed to delete a mailbox database but couldn’t getting the error shown below: PROBLEM: The mailbox database ‘Mailbox Database 2 G-L’ cannot be deleted. Mailbox Database 2 G-L Failed Error:This mailbox database contains one or more mailboxes, mailbox plans, archive mailboxes, or arbitration mailboxes. To […]
More...
Problem: When trying to deploy an OVF using the web interface, you getting this error message below. Even when you have installed the client integration plugins it still doesn’t work. “Client Integration Plug-in must be installed to enable OVF functionality” Solution: 1. Uninstall any/all existing Vmware client integration plugins from: Control Panel->Add/Remove Programs 2. Restart […]
More...